DB-200 - H-Bridge Driver

DB-200 Product Info Page


The DB-200 is similar to the original DB-100 DC-switching unit. This unit however uses H-Bridge(s) to drive up to six DC motor loads directly. Nominal max is 4Amp per motor, 15Amp trip. These, like the DB100, are controlled via 'digital circuit breaker' progamability. Initially, this is on a design-by design basis within the house systems of a coach or towable.

Communication are via the ubiquitous RV-C CAN-BUS found in modern coaches or those retrofitted for this. Programming may be done With RVC Software Downloader or with PROM-Ice.

Troubleshooting note:
##The AGS/ Generator function may be on by default. If so, and TM102 is also enabled, the generator may toggle between off and running (in the case of both units enabled. Use one or the other. To turn 'off', Use DB200 Config Tool, select tab Generator/AGS, in 'Generator' section, change 'Type' to _None_ then reboot DB200##

DB-200 Part Numbers